2 Stroke Single Cylinder 52CC Gasoline Pile Driver Engine T Post Driving Head

  
2 Stroke Single Cylinder 52CC Gasoline Pile Driver Engine T Post Driving Head. 2 Stroke 52CC Gasoline Gas Powered T Post Push Pile Driver Engine Fence Farm. Engine type: two-stroke, air cooling, single cylinder. Fuel type: mixed Oil (25 gasoline: 1 motor oil). Fuel tank capacity: 1 L. Power & speed: 1900W(2.3HP)/6500r/min. Torque & speed: 2.5N. Fuel consumption rate: =0.6L/h. Starter System: Hand pull start. Post driving head mount size: 55? Comes with 2 post driving head 55?

70mm makes this a perfect choice for T-Posts, Y-Posts and ground rods. Vibration absorbing springs for stable operation. Superior cooling vents for prolonged use and smooth running. Interlocking controls with throttle adjuster.

Rubber and plastic sponge handle which can greatly reduce the recoil force of the machine. Lightest weight, simple one man operation, lowest displacement. This gasoline post driver provides maneuverability and usability of being able to drive almost anything. 1 x petrol post driver.

2 x post driving head. 1 x mixing oil bottle. Please allow 1-3cm errors due to manual measurement. Item color displayed in photos may be showing slightly different on your computer monitor since monitors are not calibrated same. If the pile driver has the problem of not hammering.

Whether too much butter is added at the place where the butter is added, clean up the excess oil in the cylinder before disassembling and re-add about 20g of high temperature resistant butter. The speed of the carburetor can be slightly fine-tuned. If the impact frequency is too high, it can be lowered if the hand cannot hold it.

Otherwise, the impact frequency should be increased. Note that it is fine-tuning. The machine is not easy to start. First, check the ratio of oil: gasoline: oil = 25:1, be sure to use a good second-flush oil.

The starter rope is pulled out an arm's distance, and it can be started by pulling it two or three times in a row, but it is also related to the temperature, and sometimes it needs to be pulled several times. When the cold engine starts, close the damper (for good start, the warm engine can be opened and start) and open the damper after the machine is normal. Feedback is very important to us. It is impossible to address issues if we do not know about them! Faction is our ultimate goal.

We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount.

Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday.